⚠️ Hyundai manufacturer position
Hyundai Motor UK warranty excludes fuel contamination. Use GDS and UK workshop manuals for tank module removal, filter replacement, and rail priming.
Vehicle information
| Make | Hyundai |
|---|---|
| Model | Kona |
| Market status | Sold new in the UK 2017–present |
| Body styles | SUV |
| Generations | OS (2017–2023), SX2 (2023–present) |
| Engine options | Petrol: 1.0 and 1.6 T-GDI petrol Diesel: Diesel offered on early UK Kona — limited later line-up Hybrid: Hybrid N Line Electric: Kona Electric — no fuel tank |
| Fuel tank capacity | Approx. 50 L (petrol/hybrid) — N/A on Kona Electric |
| Fuel system | Petrol GDI on ICE; BEV has no traction fuel system |
| Access method | Fuel pump access under rear seat on many UK Hyundai cars — confirm by model |
| Anti-siphon | Yes — integrated filler neck design |
| Service portal | Hyundai GDS / Hyundai UK technical literature |
Misfuel risk Moderate
Mixed UK fleet of petrol, hybrid, and full EV — always verify badge and filler before fuel extraction procedure.
If the engine was not started
Do not start the engine or cycle the ignition to RUN (diesel pre-heat). Have the vehicle recovered if needed and fuel extracted from the tank before any crank attempt.
If the engine was started
If the engine ran on wrong fuel, expect inspection of the high-pressure pump, injectors, fuel rail, filters, and possibly the DPF. AdBlue system is separate but should be checked for cross-contamination only if the wrong cap was used.
Access procedure
- Switch off ignition, apply parking brake, and disconnect the 12 V battery negative terminal where OEM procedure requires.
- Relieve fuel system pressure per workshop manual (fuse pull or diagnostic command).
- Access the fuel pump module via the approved panel or by lowering the tank as specified.
- Extract contaminated fuel with an approved extraction unit; label waste for hazardous waste consignment.
- Replace fuel filter(s) and inspect lines; flush if OEM specifies after misfuel.
- Refit components, reconnect battery, and prime the fuel system before a short road test.
- Record tank capacity drained and disposal paperwork for duty-of-care compliance.
Notes
- Kona Electric: misfuel not applicable — see EV fluid guidance if wrong cap used
Frequently asked questions
What should I do if I put petrol in my Hyundai Kona diesel?
Do not start the engine or turn the ignition on. Have the fuel extracted from the tank and the fuel system checked by a GBIFDA-certified technician using Hyundai service information. Contaminated fuel must be disposed of under your duty of care (Environmental Protection Act 1990).
Can I drive my Hyundai Kona after a small amount of wrong fuel?
No — even a small amount of petrol in a diesel common-rail system can damage the high-pressure pump and injectors. Follow the OEM fuel extraction and system flush procedure before driving.
Will misfuel damage void my Hyundai warranty in the UK?
Hyundai warranty terms typically exclude damage from incorrect fuel or contaminated fuel. Keep invoices from an authorised repairer or GBIFDA-certified operator; disputes may be referred to the Motor Ombudsman or Trading Standards.
Where is the fuel pump access on a Hyundai Kona?
On most UK-market examples, access is via a service panel under the rear seat or in the load area — confirm in Hyundai workshop manuals for your chassis code. Saddle-tank designs may need both sides drained.
Need professional misfuel recovery?
Find a certified operator or read consumer guidance for your next steps.
Find an operator Consumer guidance